Saftronics VG10 - Dynamic Torque Vector AC Drive
(Obsolete FINCOR Series 6600)

• Saftronics VG10 - Dynamic Torque Vector AC Drives
• Pricing, Dimensions & Weights
• Optional DC Link Reactors
• Options & Accessories
  • Palm Pilot Saflink Kit
  • Relay Output Card
  • SR10 Radio Modem Kit
  • Digital I/O Interface Card
  • Analog I/O Interface Card
  • SF-10 Ethernet Module
  • PGX Encoder Feedback Card
  • Encoder + Analog Output Card
  • PG Feedback Card (VG10 only)
  • PG Feedback Card (VG10 only)
  • Synchronized Operation Card (VG10 only)
  • 24 VDC or 24/120 VAC Interface Card Kit (PC10, GP10 or VG10 Inverter)
  • Air Pressure Sensor + V/I Converter Output Card
• SDBU - Dynamic Brake Module
  • 208-230V Dynamic Brake Packages
  • 460V Dynamic Brake Packages
• Ratings Efficiency & Watts Loss (230, 460VAC)
• Standard Specifications
• For Drive Dimension Sheets, contact Joliet Technologies
  • DC Link Reactor 100 HP and Above
• Basic Connection Diagrams
  • Basic Connection Diagram (Sink Logic, Mainly America)
  • Basic Connection Diagram to PLC (Sink Logic, Mainly America)
  • Basic Connection Diagram (Source Logic, Mainly Europe)
  • Basic Connection Diagram to PLC (Source Logic, Mainly Europe)
• For Spare Parts, contact Joliet Technologies

Options & Accessories

Name	Synchronized operation card (VG10 only)
Part Number	SOPCG11SSY
Function	To perform position control by pulse train input, synchronized operation of 3 motors (wait-and-synchro nize operation, simultaneous-start-and-synchronize operation, and proportional speed ration operation).
Specifications	Control Speed Control Range 1 : 1200 RPM (3 to 3600r/min) Maximum speed 3600 r/min (120 Hz) Speed Control accuracy +1-0.02% Speed Control response 40 Hz   Applicable encoder (generator) No. of output pulses: 20 to 3000 P/R /VB phase (incremental) Maximum response frequency: 100 kHz Wiring length: 100m (totem pole) 1 20 (open collector)  Pulse output method: Totem pole 1 open collector. Output current 7mA or more.   Input Terminal XA, XB, CM Connect A- and B-phase output signal of master rotary encoder XZ, CM Connect Z-phase output signal of master rotary encoder YA, YB, CM Connect A- and B-phase output signal of feedback or master rotary encoder YZ, CM Connect Z -phase output signal of master rotary encoder Output Power Source None (1) Use external power source when more than one PG feedback cards are used and the total input current exceeds 120mA. (2) Take note of the power source matches the specifications of the applied rotary encoder.
Connection Diagram

* Pin J2 may be connected on either the 12V or 15V side.

The above diagrams are used when the drive internal power source is used.
When using external power source, perform connection similar to the above connection, be referring to footnote2 when using external power supply of the PG feedback card.

To purchase any Saftronics drives or information, contact us at: 
Phone (815) 725-9696, 
Toll Free (866) 492-9888,
Fax (815) 725-9393 or 
E-mail info@joliettech.com