VMX Series System Protection

World-class motor & system protection...

in a soft starter that is easy to install, easy to wire & easy to use

Separate Start & Run Overload Protection
Two programmable overload trip 100%. curves allow for the thermal capacity required to start the load, while providing more closely matched overload protection during the run time.

Real-Time Thermal Modeling
A dynamic thermal register continuously calculates motor operating temperature even when your motor is not running. Knows when the motor is cool enough for a successful restart.

Retentive Thermal Memory
Remembers the motor thermal condition even in the event of a power loss or blackout. Extrapolates motor temperatures using a real-time clock.

Dynamic Reset Capacity
Overload will not reset until thermal capacity in the motor is sufficient for a successful restart. Starter learns and retains this information from previous starts.

Duty Cycle Protection

• Back-spin timer ensures coast-down before restart
• Minimum time between starts lock-out
• Starts-per-hour lockout to prevent motor damage

Equipment ground fault trip and monitoring (residual current method)
PTC thermistor input for use on motors with embedded PTC temperature sensors
Current imbalance trip and biasing of the thermal register
Phase loss protection based on current and voltage
Electronic shear pin trip (overcurrent) with trip delay
Load loss trip (under current) with trip delay
Phase rotation protection
Pre-start shorted load protection checks for motor lead or winding damage
Running short circuit trip acts like a high speed "electronic fuse"
Shorted SCR lockout, defeatable for "must run" situations
Bypass discrepancy monitoring ensures the Bypass Contactor closes
Over temperature trip keeps track of heat sink temperature to avoid SCR damage
Shunt trip detects welded contactor or multiple shorted SCRs (when used with shunt trip breaker)
Remaining thermal capacity metering, to predict overloads
Metering of A, B, C phase and ground fault currents

The features of a protection relay at no additional cost!

Unique, Compact Design

• Narrow width for MCC (motor control center) mounting
• Integrated bypass contactor
• Low profile for use in pump panels & other shallow enclosures
• Remote mount keypad capability
• Generous power terminal landing pads
• Pull apart control terminals for easy assembly & wiring
• Built-in features eliminate adding discreet devices
• Process control timers, metering, decel control, communications, and more

Remote Mount Keypad Option
Remotely mount the keypad and display up to 10 feet from the base unit, with NEMA 1 or NEMA 4/12 bezels

Flexible Inputs & Outputs Put You in Control!

1. Easy access RS-485 comm port
   with Modbus RTU protocol built-in, no add-on communications module needed.
2. Simple control wiring:
   2 or 3 wire Start/Stop, N.C Interlock, PIC IE-Stop, Jog and Dual Ramp, all operated at 24VDC for safety.
3. Dedicated fault triac
   with opto-isolation for PLC interface or connecting to an external relay.
4. Emergency Bypass Input simple contact closure allows for independent control of the Bypass contactor when emergency across-the-line starting is needed. (For heavy duty applications requiring full voltage, line start capability, see the VMX-HD Series).
5. 3 dry contact relays:
   2 FORM C and 1 FORM A, all fully programmable for over 30 functions including, Run, At Speed, End of Decel, nine other status indicators and 13 trip indicators, including an option to flash on certain faults.

Contact Joliet Technologies for pricing,
availability and freight options.
Phone: (815) 725-9696 or
Toll Free: (866) 492-9888
Fax: (815) 725-9393
E-mail: info@joliettech.com
RFQ - Request for Quote